Centre plate between the 2 post to cover the hydraulic pipes and steel synchronizing ropes. It is the most common type of lift, but the plate can be considered an obstruction when removing gearboxes on a transmission jack, however this lift is suitable for low ceiling workshops.
The SAL224 two-post lift is designed for commercial use and hobbyists alike. Powerful 2.2KW motor and secure locking systems, this lift meets the international safety standards. With fewer serviceable parts and reduced maintenance than conventional type lifts resulting in minimal maintenance. Maximise your space and speed up vehicle maintenance by adding this perfect Lift to your shop.
This model has an open-top design giving complete height freedom with a max of 4000KG lifting capacity, making it perfect for garages with low ceilings or giving you the ability to lift vehicles with canopies or SUV’s without a height restriction.
Stats prove that for every two-post lift installed in a workshop, It increases the amount of work that can be done by 30% by reducing the time required to repair the vehicle by having easier and safer access to parts of the vehicle like underbody work and wheel service work.
Having a 2-post lift also lowers the risk of injury or damage to the vehicle by raising it off the ground safely and out the way of tools, equipment and people moving around on the ground.
SAL224 – 2 Post Base Lift – 4.2 Ton, 220V
Floor plate design, more suitable for low ceiling workshops
Manual lock release
Dual cylinders located in Master and slave column,
Dynamic test 115% of the rated capacity.
Static test: 150% of the rated capacity
Dual antic skidding safety device from column ladder safety to hydraulic seal protection
Special hydraulic system designed to avoid overload running
ABS control box, 24v low voltage control system
High strength chain drive system
High quality seals from Italy
Quality power rack
CE CertifiedTechnical Information
Lifting capacity : 4200 kg
Min Height : 110 mm
Lifting Height : 1900 mm
Column Height : 2826 mm
Width between columns : 2800 mm
Power of motor : 2.2 kw
Oil Pressure : 18 MPa
Power Supply : 220 v
Lifting time : 50 s
Lowering Time : 40 s